Montero Sport XS 2WD V6-3.5L SOHC (2001)
Air Bag Control Module: Service and Repair
Deployed Air Bag Module Disposal
Before disposing of a vehicle which is equipped with air bags or seat belts with pre-tensioner, or when disposing of the air bags or seat belt pre-tensioner
themselves, the following procedures must be used to deploy the air bags or operate the seat belt pre-tensioner before disposal.
After deployment and operation, the air bag module and seat belt pre-tensioner should be disposed of in the same manner as any other scrap parts,
adhering to local laws and/or legislation. Observe the following precautions during air bag disposal:
1. The inflator will be quite hot immediately following deployment, so wait at least 30 minutes to allow it cool before attempting to handle it.
2. Do not put water or oil on the air bag after deployment or on the seat belt pre-tensioner after operation.
WARNING: It after following these precautions, any material does get into the eyes or on the skin, immediately rinse the affected area
with a large amount of clean water. If any irritation develops, seek medical attention.
3. There may be material on the deployed air bag module or the operated seat belt pre-tensioner, that could irritate the eye and/or skin. Wear gloves
and safety glasses when handling a deployed air bag module or the operated seat belt pre-tensioner.
4. Tightly seal the air bag module and seat belt pre-tensioner in a strong plastic bag for disposal.
5. Be sure to always wash your hands after completing this operation.
