Montero Sport XS 2WD V6-3.5L SOHC (2001)
YES: There is no action to be taken.
NO: Go to Step 6.
STEP 6. Check driver's side door switch connector E-33 for damage.
Q: Is driver's side door switch connector E-33 in good condition?
YES: Go to Step 7.
NO: Repair them. Then check that the malfunction is eliminated.
STEP 7. Check the harness wires between the driver's side door switch connector E-33 and ETACS-ECU connector D-11.
NOTE: After inspecting intermediate connector E-42, junction block D-14, inspect the wire. If intermediate connector E-42, junction block D-14 are
damaged, repair or replace them. Refer to Harness Connector Inspection.
Q: Are the harness wire between the driver's side door switch connector E43 and ETACS-ECU connector D-11 in good condition?
YES: Replace the ETAS-ECU.
NO: Go to step 8.
STEP 8. Recheck for malfunction.
Q: Is a malfunction eliminated?
YES: This diagnosis is complete. (If no malfunctions are not found in all steps, an intermittent malfunction is suspected. Refer to How to Use
Troubleshooting/Inspection Service Point.)
NO: Go to step 1.