Montero SR 4WD V6-3.5L SOHC (1997)
Drive Belt: Testing and Inspection
Power Steering
DRIVE BELT TENSION
1. Measure the flexion of the V belt when it is subjected to a force of 98 N (22 lbs.) in the place shown.
Standard value:
When checked: 13.8 - 1 7.8 mm (.54 - .70 inch)
When an old belt is installed: 14.8- 16.8 mm (.58-.66 inch)
When a new belt is installed: 10.7- 13.7 mm (.42-.54 inch)
2. If the flexion value is outside the standard value, adjust by the following procedure.
a. Loosen tension pulley fixing nut.
b. Tighten the fixing nut to the following torque.
Tightening torque: 9.8 - 19.6 Nm (7 - 14 ft.lbs.)
c. Adjusting belt tension with adjusting bolt.
d. Tighten the fixing bolt.
