Montero SR 4WD V6-3.5L SOHC (1997)
Transmission Position Switch/Sensor: Testing and Inspection
TROUBLESHOOTING HINTS
If the output of the park/neutral position switch is abnormal even though the results of the checking of the park/neutral position switch harness and
of the component itself are normal, the cause is probably improper adjustment of the control cable.
INSPECTION
Using Scan Tool
Ignition switch-ST
Park/Neutral Position Switch
HARNESS INSPECTION
STEP 1. Measure the power supply voltage of the park/ neutral position switch.
-
Engine control module connector: Disconnected
-
Park/neutral position switch connector: Disconnected
-
Ignition switch: START
Voltage (V): Battery positive voltage
OK: GO TO STEP 2
NG: Check the power supply circuit.
STEP 2. Check for continuity between the park/neutral position switch and the engine control module.
-
Engine control module connector: Disconnected
-
Park/neutral position switch connector: Disconnected
NOTE:
-
Touch the ohmmeter probes to both ends of the harness.
OK: GO TO STEP 3
NG: Repair the harnesses. (A5 - 71, A6 - 91)