Montero SR 4WD V6-3.5L SOHC (1997)
1. Install nuts that are no longer needed to the four bolts on the rear side of the air bag module, and tie on some thick wire to secure to the wheel.
2. Take the SRS air bag adaptor harness B that is connected to the wires, pass it beneath the old tire wheel assembly, and connect it to the air bag
module.
3. Insert the air bag module into the wheel, and secure it with wires that are tied to the bolt holes, the air bag should face upward.
CAUTION: Leave some space below the wheel for the adaptor harness. If there is no space, the reaction when the air bag deploys could
damage the adaptor harness.
4. Place three old tires, without wheels, on top of the tire secured to the air bag module.
Front Passenger's Side
1. Connect the deployment wires to the SRS air bag adapter harness A, pass it beneath the tire, and wheel assembly, and connect it to the air bag
module.
2. Pass the thick wires into the hole of the air bag module bracket, and secure it to the wheel of the old tire with wheel (4 locations), with the air
bag facing upwards.
CAUTION:
1. Leave some space below the wheel for the deployment wires.
If there is no space, the reaction of the air bag deployment could result in damage of the adaptor harness.
2. While deployment takes place, do not have the connector of the SRS air bag adaptor harness A inserted between the tires.
