Montero SR 4WD V6-3.5L SOHC (1997)
2. When installing the torsion bar, align the white mark on the serrated section of the torsion bar with the mating mark on the anchor arm.
b. Anchor collar installation (3).
Install the anchor collar with the slit downward.
c. Bump stopper and bump stopper bracket clearance adjustment (-).
1. Tighten the adjusting nut until the protruding length of the anchor bolt is 80 mm (3.15 inch) or less.
2. With the vehicle in an unladen condition, measure the distance from the bump stopper to the bump stopper bracket to check if it is at the
standard value.
Standard value: 21-23 mm (.83-.91 inch)
3. If outside the standard value, adjust the anchor bolt with the adjusting nut.
