Montero SR 4WD V6-3.5L SOHC (1997)
2. Apply multi-purpose grease to the contact surfaces of the companion flange oil seal and the washer companion flange.
3. Install the drive pinion assembly and companion flange with the mating marks properly aligned, and then use the special tools to
tighten the companion flange self-locking nut to the specified torque.
4. Use the special tools to measure the drive pinion rotation torque (with the oil seal) to confirm that the drive pinion preload is at the
standard value.
Standard value:
New (with anti-rust agent): 0 5 - 0.7 Nm (4.3 - 6.1 inch lbs.)
New/reused (gear oil applied): 0.35 - 0.45 Nm (3.1 - 3.9 inch lbs.)
5. If the measured value is not within the standard value range; check for incorrect installation of the oil seal or incorrect tightening of the
self-locking nut.
E. Differential gear backlash adjustment. (-)
1. Assemble the side gears, side gear thrust spacers, pinion gears and pinion washers into the differential case.
2. Provisionally install the pinion shaft.
NOTE: Do not drive in the lock pin yet.
3. Insert a wedge between the side gear and the pinion shaft to lock the side gear.
