Montero SR 4WD V6-3.5L SOHC (1997)
5. Change the thickness of the friction disc so that the clearance (D - C) between the differential case and the spring plate (vehicles with
limited slip differential) or friction disc (vehicles with rear differential lock) is at the standard value.
Standard value: 0.06-0.20 mm (0.0024-0.0079 inch)
6. Remove the spring plates, spring discs, friction plates and friction disc.
7. Measure the dimension (H) from one end of the thrust washer to the other end.
8. Calculate the dimension (I) between the thrust washer contact surfaces when differential cases (A) and (B) are combined.
(I = D + J + K)
NOTE: Dimension (D) is the distance between the spring plate contact surfaces when differential cases (A) and (B) are combined.
9. Change the thickness of the thrust washer so that the clearance (I-H) between the thrust washer and the differential case is at the standard
value.
Standard value: 0.05-0.20 mm (0.0020-0.0079 inch)
NOTE: There are three sizes of new thrust washers: 1.50 mm (0.0591 inch), 1.60 mm (0.0630 inch) and 1.70 mm (0.0670 inch).
10. Insert the thrust washer as shown in the illustration, and then select a thrust washer so that the difference between the left and right
