Montero SR 4WD V6-3.5L SOHC (1997)
1. Use the special tool to press in the journal bearing on one side, and take out the journal bearing on the opposite side.
2. Insert the special tool in the other side and press the journal to remove the first journal bearing that was pushed.
CAUTION: Do not tap the journal bearings to remove them, as this will upset the balance of the propeller shaft.
ASSEMBLY
Assembly in reverse order as Disassembly.
NOTE: Assembly service points as follows:
A. Journal/journal bearing installation. (3 & 4)
1. Fit the journal onto the yoke.
2. Use the special tool to press the journal bearing into the yoke until the snap ring groove is fully visible.
