Montero XLS 4WD V6-3.5L SOHC (2001)
Wheel Speed Sensor: Service and Repair
REMOVAL AND INSTALLATION
NOTE: The front and rear ABS rotors are integrated with the drive shaft and cannot be disassembled.
REMOVAL SERVICE POINTS
<<A>> FRONT SPEED SENSOR REMOVAL
1. Remove the three splash shield clips and the two bolts shown in the illustration, and then disconnect the front wheel speed sensor connector.
CAUTION: Be careful when handling the projection at the tip of the speed sensor and the toothed edge of the ABS rotor so as not to damage
them by contacting other parts.
2. Remove the front wheel speed sensor.
<<B>> REAR SPEED SENSOR REMOVAL
CAUTION: Be careful when handling the projection at the tip of the speed sensor and the toothed edge of the ABS rotor so as not to damage
them by contacting other parts.
