Montero XLS 4WD V6-3.5L SOHC (2001)
STEP 6. Check the harness wires between power window relay connector D-219 and fusible link (4).
NOTE: After checking junction block connector D-221 and intermediate connector D-28, check the wires. If junction block connector D-221 and
intermediate connector D-28 are damaged, repair or replace them. Refer to Harness Connector Inspection.
Q: Are the harness wires between power window relay connector D-219 and fusible link (4) in good condition?
YES: There is no action to be taken.
NO: Repair them. The power windows should work normally.
STEP 7. Check the power window main switch ground circuit at the power window main switch connector H-05.
1. Disconnect the power window main switch connector H-05 and measure at the harness side.
2. Measure the resistance between terminal 3 and ground.
Q: Is the resistance less than 2 ohm?
YES: Go to Step 10.
NO: Go to Step 8.
