Montero XLS 4WD V6-3.5L SOHC (2001)
NOTE: After checking intermediate connectors F-24, D-26 and D-28 and junction block connectors D-207 and D-221, check the wires. If intermediate
connectors F-24, D-26 and D-28 and junction block connectors D-207 and D-221 are damaged, repair or replace them. Refer to Harness Connector
Inspection.
Q: Are the harness wires between sunroof motor assembly connector F-02 and fusible link (2) in good condition?
YES: There is no action to be taken.
NO: Repair or replace them. The sunroof should work normally.
STEP 7. Check the sunroof motor assembly power supply circuit [ignition switch (IG2)] at the sunroof motor assembly connector F-02 by
backprobing.
1. Do not disconnect the sunroof motor assembly connector F-02.
2. Turn the ignition switch to "ON" position.
3. Measure the voltage between terminal 2 and ground by backup robing.
Q: Is the voltage approximately 12 volts (battery positive voltage)?
YES: Go to Step 10.
NO: Go to Step 8.
