Montero XLS 4WD V6-3.5L SOHC (2001)
STEP 9. Check the harness wires between combination meter connector D-03 and ignition switch (IG1).
NOTE: After checking junction block connectors D-210 and D-208, check the wires. If junction block connectors D-210 and D-208 are damaged,
repair or replace them. Refer to Harness Connector Inspection.
Q: Are the harness wires between combination meter connector D-03 and ignition switch (IG1) in good condition?
YES: There is no action to be taken.
NO: Repair or replace them. The seat belt warning light should work normally.
STEP 10. Check combination meter connector D-04 and ETACS-ECU connector D-224 for damage.
Q: Are combination meter connector D-04 and ETACS-ECU connector D-224 in good condition?
YES: Go to Step 11.
NO: Repair or replace them. Refer to Harness Connector Inspection. The seat belt warning light should work normally.
