mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2135 > < Initial Inspection and Diagnostic Overview|Page 2133
Page 105
background image

STEP 11. Check the harness wire between combination meter connector D-04 and ETACS-ECU connector D-224.

Q: Is the harness wire between combination meter connector D-04 and ETACS-ECU connector D-224 in good condition?

YES: There is no action to be taken.
NO: Repair it. The seat belt warning light should work normally.

K - Charts

Ignition key hole illumination light: Ignition key hole illumination light does not work normally

Initial Inspection and Diagnostic Overview|Page 2135 > < Initial Inspection and Diagnostic Overview|Page 2133