Montero XLS 4WD V6-3.5L SOHC (2001)
NOTE: After checking intermediate connector D-26 and junction block connector D-207, check the wires. If intermediate connector D-26 or junction
block connector D-207 are damaged, repair or replace them. Refer to Harness Connector Inspection.
Q: Are the harness wires between dome light connector F-03 and ETACS-ECU connector D-222 in good condition?
YES: Replace the ETACS-ECU. The dome light should illuminate.
NO: Repair them. The dome light should illuminate.
STEP 4. Check the dome light bulb.
Q: Is the dome light bulb in good condition?
YES: Go to Step 5.
NO: Replace it. The dome light should illuminate.
STEP 5. Check the dome light power supply circuit at the dome light connector F-03.
1. Disconnect the dome light connector F-03 and measure at the harness side.
2. Measure the voltage between terminal 1 and ground.
Q: Is the voltage approximately 12 volts (battery positive voltage)
YES: Replace the dome light. The dome light should illuminate.
NO: Go to Step 6.
STEP 6. Check dome light connector F-03 for damage.
Q: Is dome light connector F-03 in good condition?
YES: Go to Step 7.
NO: Repair or replace it. Refer to Harness Connector Inspection. The dome light should illuminate.
