mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2183 > < Initial Inspection and Diagnostic Overview|Page 2181
Page 153
background image

Connectors

CIRCUIT OPERATION

The ETACS-ECU will sound the theft-alarm horn and horn if the theft-alarm system or the keyless entry system answerback is triggered.

TECHNICAL DESCRIPTION (COMMENT)

The theft-alarm horn and horn are shared by the keyless entry system. If the theft-alarm horn and horn sounds normally through the keyless entry system
answerback, the ETACS-ECU may be defective.

TROUBLESHOOTING HINTS

-

Malfunction of the theft-alarm horn

-

Malfunction of the horn Malfunction of the theft-alarm horn relay

-

Malformation of the horn relay Malfunction of the ETACS-ECU

-

Damaged harness wires or connectors

DIAGNOSIS

Required Special Tool:

-

MB991223: Test Harness Set

STEP 1. Check the keyless entry system horn answerback. Activate the keyless entry system horn answerback. (Refer to Keyless Entry System -
On-vehicle Service - Enabling/disabling the Answerback Function)

Q: Does the horn answerback function work?

YES: Replace the ETACS-ECU. The horn should sound when the theft-alarm system is triggered.
NO: Go to Step 2.

STEP 2. Check trouble symptom.

Q: Which horn does not sound?

The theft-alarm horn does not sound.: Go to Step 3.
The horn does not sound.: Go to Step.

Initial Inspection and Diagnostic Overview|Page 2183 > < Initial Inspection and Diagnostic Overview|Page 2181