mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2188 > < Initial Inspection and Diagnostic Overview|Page 2186
Page 158
background image

STEP 13. Check the horn. Connect the battery as shown and check that the horn sounds.

Q: Is the horn in good condition?

YES: Go to Step 14.
NO: Replace it. The horn should sound when the theft-alarm system is triggered.

STEP 14. Check the horn relay.

Q: Is the horn relay in good condition?

YES: Go to Step 15.
NO: Replace it. The horn should sound when the theft-alarm system is triggered.

STEP 15. Check the horn relay power supply circuit at the horn relay connector A-10X.

1. Disconnect the horn relay connector A-10X and measure at the relay box side.

2. Measure the voltages between terminals 3, 5 and ground.

Q: Are the voltages approximately 12 volts (battery positive voltage)?

Initial Inspection and Diagnostic Overview|Page 2188 > < Initial Inspection and Diagnostic Overview|Page 2186