Montero XLS 4WD V6-3.5L SOHC (2001)
STEP 2. Check ETACS-ECU connector D-222 for damage.
Q: Is ETACS-ECU connector D-222 in good condition?
YES: Go to Step 3.
NO: Repair or replace it. Refer to Harness Connector Inspection. The ignition switch (ACC) input signal should be able to be checked and the
functions, which are described in the "Technical Description (comment)," should work normally.
STEP 3. Check the harness wires between ETACS-ECU connector D-222 and ignition switch (ACC).
NOTE: After checking junction block connector D-208, check the wires. If junction block connector D-208 is damaged, repair or replace it. Refer to
Harness Connector Inspection.
Q: Are the harness wires between ETACS-ECU connector D-222 and ignition switch (ACC) in good condition?
YES: There is no action to be taken.
NO: Repair them. The ignition switch (ACC) input signal should be able to be checked and the functions, which are described in the "Technical
Description (comment)," should work normally.
Inspection Procedure Q-2
The ignition switch (IG1) signal is not sent to the ETACS-ECU
