Montero XLS 4WD V6-3.5L SOHC (2001)
Ignition Switch (IG1) Input Circuit
Connectors
CIRCUIT OPERATION
-
The ETACS-ECU operates various functions according to the input signal from the ignition switch (IG1).
-
This circuit will work as a backup circuit if the battery circuit to the ETACS-ECU is open circuit.
TECHNICAL DESCRIPTION (COMMENT)
The ignition switch (IG1) input signal is used to operate the following devices or functions:
-
Ignition key reminder tone alarm function
-
Light reminder tone alarm function
-
Seat belt tone alarm function
-
Power window timer function
-
Sunroof timer function
-
Seat belt warning light
-
Ignition key hole illumination light
-
Headlight automatic shutdown function
-
Turn-signal light
-
Dome light dimming function
If the signal fails, these devices will not work normally.
TROUBLESHOOTING HINTS
-
Malfunction of the ETACS-ECU
-
Damaged harness wires or connectors
DIAGNOSIS
Required Special Tools:
-
MB991223: Test Harness Set
-
MB991502: Scan Tool (MUT-II)
-
MB991529: Diagnostic Trouble Code Check Harness
STEP 1. Check the ignition switch (IG1) circuit at the ETACS-ECU connector D-222.