Montero XLS 4WD V6-3.5L SOHC (2001)
NOTE: After checking junction block connector D-208, check the wires. If junction block connector D-208 is damaged, repair or replace it. Refer to
Harness Connector Inspection.
Q: Are the harness wires between ETACS-ECU connector D-222 and ignition switch (IG1) in good condition?
YES: There is no action to be taken.
NO: Repair them. The ignition switch (IG1) input signal should be able to be checked and the functions, which are described in the Technical
Description (comment)," should work normally.
Inspection Procedure Q-3
The key reminder switch signal is not sent to the ETACS-ECU
