Montero XLS 4WD V6-3.5L SOHC (2001)
STEP 6. Check the harness wires between driver's seat belt switch connector F-18 and ETACS-ECU connector D-224.
NOTE: After checking intermediate connector D-125, check the wires. If intermediate connector D-125 is damaged, repair or replace it. Refer to
Harness Connector Inspection.
Q: Are the harness wires between driver's seat belt switch connector F-18 and ETACS-ECU connector D-224 in good condition?
YES: Replace the ETACS-ECU. The driver's seat belt switch input signal should be able to be checked and the functions, which are described in the
"Technical Description (comment)," should work normally.
NO: Repair them. The driver's seat belt switch input signal should be able to be checked and the functions, which are described in the "Technical
Description (comment)," should work normally.
Inspection Procedure Q-9
The driver's or front passenger's door switch or door switches signal is not sent to the ETACS-ECU
