Montero XLS 4WD V6-3.5L SOHC (2001)
NOTE: After checking intermediate connector D-25, check the wires. If intermediate connector D-25 is damaged, repair or replace it. Refer to Harness
Connector Inspection.
Q: Are the harness wires between driver's door lock actuator switch connector H-10 and ETACS-ECU connector D-223 in good condition?
YES: Replace the ETACS-ECU. The input signal from the driver's door lock actuator switch should be able to be checked and the functions, which
are described in the "Technical Description (comment), should work normally.
NO: Repair them. The input signal from the driver's door lock actuator switch should be able to be checked and the functions, which are described in
the "Technical Description (comment)," should work normally.
STEP 8. Check the front passenger's door lock actuator switch.
Q: Is the front passenger's door lock actuator switch in good condition?
YES: Go to Step 9.
NO: Replace it. The input signal from the front passenger's door lock actuator switch should be able to be checked and the functions, which are
described in the "Technical Description (comment)," should work normally.
STEP 9. Check the front passenger's door lock actuator switch ground circuit at front passenger's door lock actuator switch connector H-24.
1. Disconnect front passenger's door lock actuator switch connector H-24 and measure at the harness side.
2. Measure the resistance between terminal 3 and ground.
