Montero XLS 4WD V6-3.5L SOHC (2001)
NOTE: After checking intermediate connector D-15, check the wires. If intermediate connector D-15 is damaged, repair or replace it. Refer to Harness
Connector Inspection.
Q: Are the harness wires between front passenger's door lock actuator switch connector H-24 and ETACS-ECU connector D-223 in good
condition?
YES: Replace the ETACS-ECU. The input signal from the front passenger's door lock actuator switch should be able to be checked and the functions,
which are described in the "Technical Description (comment)," should work normally.
NO: Repair them. The input signal from the front passenger's door lock actuator switch should be able to be checked and the functions, which are
described in the "Technical Description (comment)," should work normally.
STEP 14. Check the rear door lock actuator switch (LH).
Q: Is the rear door lock actuator switch (LH) in good condition?
YES: Go to Step 15.
NO: Replace it. The input signal from the rear door lock actuator switch (LH) should be able to be checked and the functions, which are described in
the "Technical Description (comment)," should work normally.
STEP 15. Check the rear door lock actuator switch (LH) ground circuit at rear door lock actuator switch (LH) connector H-13.
1. Disconnect rear door lock actuator switch (LH) connector H-13 and measure at the harness side.
