Montero XLS 4WD V6-3.5L SOHC (2001)
2. Measure the resistance between terminal 6 and ground.
Q: Is the resistance less than 2 ohm?
YES: Go to Step 18.
NO: Go to Step 16.
STEP 16. Check rear door lock actuator switch (LH) connector H-13 for damage.
Q: Is rear door lock actuator switch (LH) connector H-13 in good condition?
YES: Go to Step 17.
NO: Repair or replace it. Refer to Harness Connector Inspection. The input signal from the rear door lock actuator switch (LH) should be able to be
checked and the functions, which are described in the "Technical Description (comment)," should work normally.
STEP 17. Check the harness wires between rear door lock actuator switch (LH) connector H-13 and ground.
NOTE: After checking intermediate connector F-12, check the wires. If intermediate connector F-12 is damaged, repair or replace it. Refer to Harness
Connector Inspection
Q: Are the harness wires between rear door lock actuator switch (LH) connector H-13 and ground in good condition?
YES: There is no action to be taken.
NO: Repair them. The input signal from the rear door lock actuator switch (LH) should be able to be checked and the functions, which are described
in the "Technical Description (comment)," should work normally.
