mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2287 > < Initial Inspection and Diagnostic Overview|Page 2285
Page 257
background image

-

MB991529: Diagnostic Trouble Code Check Harness

STEP 1. Check the RV meter operation.

Q: Does the RV meter work normally?

YES: Go to Step 2.
NO: Solve the problem first. Refer to RV meter.

STEP 2. Check RV meter connector D-08 and ETACS-ECU connector D-224 for damage.

Q: Are RV meter connector D-08 and ETACS-ECU connector D-224 in good condition?

YES: Go to Step 3.
NO: Repair or replace them. Refer to Harness Connector Inspection. The input signal from the RV meter switch should be able to be checked and the
RV meter should work normally.

STEP 3. Check the harness wires between RV meter connector D-08 and ETACS-ECU connector D-224.

NOTE:  After checking joint connector D-02, check the wires. If joint connector D-02 is damaged, repair or replace it. Refer to Harness Connector

Initial Inspection and Diagnostic Overview|Page 2287 > < Initial Inspection and Diagnostic Overview|Page 2285