Montero XLS 4WD V6-3.5L SOHC (2001)
6.
Gather the following reprogramming equipment:
-
Memory Card 128 MByte Compact Flash MB991853
-
Memory Card Adapter PCMCIA MB991939
-
VCI unit MB991824
-
MUT-III main harness B MB991911 (red)[<].
-
2002-04 models only: 12-13 pin adapter MB991855[>].
-
"Engine Compartment/Control Module" Labels p/n MSSF-024G-00
7.
Transfer the reprogramming data from the laptop to the memory card.
8.
Remove the memory card from the laptop and install it in the VCI. Connect the VCI to the vehicle. YOU MUST DISCONNECT THE MUT-III
LAPTOP.
[>] IMPORTANT:
Both connectors of the MUT-III main harness must be plugged in to perform the reprogramming. The 12-13 pin adapter harness is required.
9.
[>] Select "1 Automatic rpg". For reprogramming details, refer to TSB-06-00-004. It will take up to 20 minutes to complete the reprogramming.
NOTE:
If the message "ECU at Current Level of VCI" appears, the PCM did not reprogram. Verify that the ROM ID is the same as the ROM ID listed
in the table below.
^
If the ROM ID is the same as or higher than the ROM ID in the table, the PCM has been reprogrammed for this concern.
^
If it is not, verify that the correct database update is in the MUT-III and was transferred to the memory card, and that the memory card is
properly installed in the VCI.
CAUTION:
DO NOT DISTURB THE HARNESS CABLES OR CONNECTIONS. INTERRUPTION DURING THE PROGRAMMING PROCESS
COULD CAUSE THE PCM TO LOSE DATA OR PREVENT FUTURE PCM REPROGRAMMING.
The table below lists the PCM part numbers and ROM IDs that will display after reprogramming.
a.
After reprogramming is completed, the new ENG ROM ID and new A/T ROM ID will display alternately with the message "Turn IG SW
