Montero XLS 4WD V6-3.5L SOHC (2001)
WARNING: Ensure that the clock spring's mating marks are properly aligned. If not, the steering wheel may not rotate completely during a
turn, or the flat harness in the clock spring could be damaged. This would present normal SRS operation and possibly cause serious injury to
the driver.
Align the mating marks of the cock spring. Turn the front wheels to the straight-ahead position. Then install the clock spring to the column switch.
Mating Mark Alignment
Turn the dock spring clockwise fully. Then turn it back approximately 3 turns counterclockwise to align the mating marks.
]]C[[ STEERING WHEEL.AIR BAG MODULE INSTALLATION
CAUTION: When installing the steering wheel, ensure that the harness of the clock spring does not become caught or tangled.
1. Before installing the steering wheel, turn the vehicle's front wheels to the straight-ahead position and align the mating marks of the clock spring.
2. After securing the steering wheel, turn the steering wheel all the way in both directions to confirm that the steering wheel rotation is normal.
]]D[[ POST-INSTALLATION INSPECTION
1. Reconnect the negative (-) battery cable.
2. Turn the ignition key to the "ON" position.
3. Does the "SRS" warning light illuminate for approximately seven seconds, and the remain off for at least five seconds after turning "OFF"?
4. If yes, the SRS system is functioning properly. If no, consult SRS WARNING LIGHT CHECK.
