Montero XLS 4WD V6-3.5L SOHC (2001)
3. Place the front seat back assembly with its back contact with the ground.
4. Connect the SRS air bag adapter harness with the deployment wires to the side air bag module connector.
CAUTION:
-
Before the deployment, see that no one is near the front seat back assembly.
-
The deployment makes the inflator of the side air bag very hot. Before handling the inflator, wait more than 30 minutes for cooling.
-
If the side air bag module fails to deploy although the procedure is respected, do not go near the module. Contact the MMSA Tech Line.
5. Disconnect the deployment wires as far from the front seat back assembly possible and connect the harnesses to the battery removes from the
vehicle. Then, deploy.
6. Remove the deployed air bag module from the seat back assembly and discard as specified in the procedure. ()
