Montero XLS 4WD V6-3.5L SOHC (2001)
WARNING:
-
Before deployment, check carefully to be sure that no one is nearby.
-
The inflator will be quite hot immediately following the deployment, so wait at least 30 minutes to allow it to cool before attempting to
handle it. Although not poisonous, do not inhale gas from air bag deployment. See Deployed Air Bag Module Disposal Procedures for
post-deployment handling instructions.
-
If the air bag fails to deploy, do not go near the module. Contact the MMSA Tech Line
6. At a location as far away from the air bag module as possible, and from a shielded position, disconnect the two connected wires from each other,
and connect them to the two terminals of the battery (which has been removed from the vehicle) to deploy the air bag.
7. Discard the deployed air bag module as specified in Deployed Air Bag Module Disposal Procedures.()
Side air bag module
CAUTION: Once disconnected, both electrodes of the side air bag module connector short automatically to prevent accidental deployment caused by
static etc. Still, in consideration of the accidental deployment, store the air bag module on flat place with deployment surface facing up. Also, do not put
anything on it.
1. Remove the front seat back assembly with side air bag module from the vehicle.
2. Connect deployment wires 6 m (20 feet) or longer with the SRS air bag adapter harness respectively. Insulate the connections with tape.
Also, connect the other ends of the deployment wires each other to short, thereby preventing the side air bag from accidental deployment caused
by static etc.
3. Place the front seat back assembly with its back contact with the ground.
4. Connect the SRS air bag adapter harness with the deployment wires to the side air bag module connector.
