Montero XLS 4WD V6-3.5L SOHC (2001)
CAUTION: When adjusting, set at the highest value of the standard value range. Be sure there is no ratcheting or catching when operating the
rack towards the shaft.
Measure the total pinion torque through the whole stroke of the rack.
NOTE: If the total pinion torque cannot be adjusted to the standard value within the specified return angle, check the rack support cover
components and replace any parts if necessary.
1. Using special tool MB991006, rotate the pinion shaft at the rate of one rotation in four to six seconds to check the total pinion torque and the
change in torque.
Standard value:
Total pinion torque: 0.6 - 1.7 Nm (5.3 - 15.0 inch lbs.)
[Change in torque: 0.4 Nm (3.5 inch lbs.) or less]
2. If the total pinion torque or the change in torque is outside the standard value, return the rack support cover within 0° angle to 30° angle, and
adjust again.
>>L<< Tab Washer/Tie Rod Installation
After installing tie rod to rack, fold tab washer end (two locations) to tie rod notch.
>>M<< Bellows Band Installation
1. Turn the adjusting bolt of special tool MB991561 to adjust the opening dimension (W) to the standard value.
NOTE:
^
The dimension (W) is adjusted by approximately 0.7 mm (0.03 inch) per one turn.
^
Do not turn the adjusting bolt more than one tam.
Standard value (W): 2.9 mm (0.11 inch)
<When more than 2.9 mm (0.11 inch)>: Screw in the adjusting bolt.
<When less than 2.9 mm (0.11 inch)>: Loosen the adjusting bolt.
