Outlander 2WD V6-3.0L (6B31) (2007)
Insert a flat-tipped (-) screwdriver as shown in the figure to remove the inside handle cover cap.
[[B]] FRONT/REAR DOOR TRIM REMOVAL
1. Insert a flat-tipped (-) screwdriver as shown in the figure to remove the door trim cap.
Using a flat-tipped (-) screwdriver as shown in the figure, remove the inside lock cable and the inside handle cable, then remove the door trim.
INSTALLATION SERVICE POINTS
]]A[[ FRONT DOOR SASH TRIM INSTALLATION
Install it with the clip attached as shown in the figure.
]]B[[ FRONT DOOR/REAR DOOR TRIM INSTALLATION
After the power window switch is installed or replaced, perform learning of the power window fully-closed position.