Outlander 2WD V6-3.0L (6B31) (2007)
/Page-1081003.png)
Install the adjuster assemblies. Install the adjuster assembly with the left side of the shoe adjusting bolt facing forward of the vehicle, and the right side
facing rearward.
>>D<< SHOE-TO-ANCHOR SPRING INSTALLATION
The shoe-to-anchor springs are not interchangeable because their spring loads are different. The one with blue paint mark should be installed to the front
of the vehicle, and the other with yellow paint to the rear of the vehicle, respectively.
NOTE: The figure describes the left rear wheel. The right rear wheel is symmetrical to that.
BRAKE LINING THICKNESS CHECK
1. Measure the lining thickness at the most worn area.
Standard value: 2.8 mm
Limit: 1.0 mm
2. If the thickness is less than the limit value, replace the right and left shoe and lining assemblies as a set.
BRAKE DRUM INSIDE DIAMETER CHECK
