Outlander 2WD V6-3.0L (6B31) (2007)
Remove the two control wiring harness clamps, and remove the thermostat housing.
INSTALLATION SERVICE POINTS
>>A<< O-RING INSTALLATION
CAUTION: Do not allow engine oil or other grease to adhere to the O-ring
Insert the O-ring to the water inlet pipe, and coat the outer portion of the O-ring with water or engine coolant.
>>B<< GASKET/THERMOSTAT HOUSING INSTALLATION
Using the special tool MD998412, install the thermostat housing while supporting the gasket.
>>C<< ENGINE COOLANT TEMPERATURE SENSOR INSTALLATION
1. Apply the specified sealant to the thread of the engine coolant temperature sensor.
Specified Sealant: 3M AAD Part No. 8731 or equivalent