Outlander 2WD V6-3.0L (6B31) (2007)
CAUTION: Notable factors for inserting pin
^
Always use the vertical press and put the auto-tensioner vertically.
^
Do not apply the load of 5,000 N (1,124 pound) or more to the rod.
^
Do not press the rod beyond the dimension shown in the illustration.
1. Put the auto-tensioner vertically to the vertical press not to be in the sideways direction.
2. Slowly close the vice to force the rod in until the hole (A) of the rod is lined up with set hole (B) of the cylinder.
3. Insert a pin into the set holes.
4. Remove the auto-tensioner from the vice.
5. Align the timing marks on the camshaft sprockets with those on the timing belt rear cover and the timing mark on the crankshaft sprocket with that
on the engine block as shown in the illustration.