Outlander 2WD V6-3.0L (6B31) (2007)
/Page-677135.png)
4. Measure the voltage between joint connector (CAN1) terminal 19 and body ground.
OK: 4.7 volts or less
Q: Do all the voltages measure 4.7 volts or less?
YES: Go to Step 58.
NO: Repair the wiring harness between joint connector (CAN1) C-103 and ETACS-ECU connector C-301.
STEP 25. Check the wiring harness for line-to-line short. Measure the resistance at ETACS-ECU connector C-301
CAUTION: Disconnect the negative battery terminal.
1. Disconnect ETACS-ECU connector C-301, and check that there is continuity at the harness side of ETACS-ECU.
2. Check that there is continuity between ETACS-ECU connector terminals 6 and 7.
OK: No continuity
Q: Is the check result normal?
YES: Go to Step 37.
NO: Go to Step 26.
STEP 26. Check the wiring harness between joint connector (CAN1) C-103 and combination meter connector C-03 for line-to-line short.
Measure the resistance at joint connector (CAN1) C-103.
1. Disconnect joint connector (CAN1), and check that there is continuity at the harness side of joint connector (CAN1).
