Outlander 2WD V6-3.0L (6B31) (2007)
/Page-897004.png)
procedure.
Connect the equipment as follows:
1.
Connect the USB cable to the VCI.
2.
When the laptop displays the MUT-III main screen connect the USB cable to the laptop.
3.
Connect the MUT-III main harness with the blue DLC connection to the VCI.
4.
Connect the blue connector of the MUT-III main harness to the vehicle's data link connector.
5.
Turn the VCI power switch ON. Verify that the indicator lamp in the upper right corner of the screen is green.
NOTE:
If the USB cable is disconnected during this procedure, a warning message will display. Close the message display by clicking on the OK
button and check USB connections.
CAUTION:
DO NOT DISTURB THE HARNESS CABLES OR CONNECTIONS. INTERRUPTION DURING THE REPROGRAMMING PROCESS
COULD CAUSE THE CONTROL UNIT TO LOSE DATA OR PREVENT FUTURE REPROGRAMMING.
ECM Reprogramming
1.
Conduct the following steps to reprogram the ECM.
a.
Turn the ignition key or knob (F.A.S.T. equipped) to the ON position. If the vehicle is equipped with the F.A.S.T. System the fob must
remain in the vehicle for the entire procedure.
b.
Select "Special Function."
