Outlander 2WD V6-3.0L (6B31) (2007)
/Page-896001.png)
Technical Service Bulletin # 08-13-007
Date: 080408
Engine Controls - Rough Idle/MIL ON/DTC's P0300-P0306
No: TSB 08-13-007
DATE: March, 2008
MODEL: 2007-08 Outlander
SUBJECT:
ENGINE CONTROL MODULE REPROGRAMMING FOR DTCS P0300 - P0306 AND ROUGH IDLE
PURPOSE
Some customers of affected vehicles may complain about a rough idle during start-up when the engine temperature is approximately 50 deg. F (10 deg.
C). They may also complain that the malfunction indicator is illuminated. A technician may find a diagnostic trouble code for a misfire (P0300 - P0306)
stored in the ECM memory. The condition may be caused by inferior quality fuel that is commonly available during summer months.
This Technical Service Bulletin advises the steps to reprogram the ECM to change the parameters associated with the air/fuel mixture when a rough idle
is detected.
AFFECTED VEHICLES
2007-08 Outlander built prior to the VIN sequence numbers shown above (last 8 of the VIN).
REQUIRED OPERATIONS
The following equipment is needed to reprogram the ECM.
^
VCI (Vehicle Communication Interface) - MB991824
^
Laptop computer with A/C power adaptor - 520924, 528535 or 547708
^
MUT-III main harness 'A' (blue connector at the DLC end) - MB991910
^
USB 2.0 cable - MB991827
^
"Engine Compartment/Control Module" labels - p/n MSSF-024G-00
^
MEDIC-II Download at M210 or higher.
If an affected vehicle has a Service Engine Soon (SES) lamp illuminated and DTCs listed in the ECM memory (before reprogramming), follow
diagnostic instructions for the applicable DTCs per the service manual information. Do not reprogram the ECM until the reason for DTCs being set is
corrected.
IMPORTANT!!!
PRIOR TO BEGINNING REPROGRAMMING OF THE ECM, ENSURE THAT THE TRANSMISSION CONTROL MODULE (TCM) IS AT
THE LATEST REPROGRAMMING LEVEL. REFER TO THE INSTRUCTIONS THAT FOLLOW TO DETERMINE THE PROGRAMMING
LEVEL. IF THE TCM IS NOT TO THE LATEST REPROGRAMMING LEVEL, FOLLOW THE INSTRUCTIONS IN THIS TSB TO
REPROGRAM THE ECM, THEN REFER TO TSB-07-23-006 TO REPROGRAM THE TCM. WHEN APPLICABLE, ALWAYS REPROGRAM
THE ECM PRIOR TO REPROGRAMMING THE TCM.
Determining Current TCM Programming Level
