Outlander 2WD V6-3.0L (6B31) (2007)
8.
Disconnect the electrical connector for the speaker.
9.
Remove the bracket for the armrest.
10.
Peel off the waterproof film.
NOTE:
Be careful to not tear or stretch the film. Do not allow the black adhesive material to contact interior trim parts.
11.
Remove the door cavity filler.
12.
Remove the inner beltline weather strip.
13.
Remove the 2 outer beltline molding retaining screws as indicated.
NOTE:
The rear screw is covered by the weatherstrip. Move the weatherstrip to one side to remove the screw. Lift the beltline outer molding from
inside of the vehicle using a trim remover.