Outlander 4WD L4-2.4L (4B12) (2008)
Removal Steps 1-15
REMOVAL SERVICE POINTS
[[A]] PRESSURE HOSE, RETURN TUBE
REMOVAL
Remove the heat protector, and push the engine assembly and transaxle assembly toward the front of the vehicle to widen the clearance. Then, remove
the pressure hose and the return tube.
NOTE:
^
When pushing the engine assembly and transaxle assembly, check that the propeller shaft assembly, front exhaust pipe, front roll stopper, and
center member assembly are already removed.
INSTALLATION SERVICE POINTS
]]A[[ RETURN HOSE INSTALLATION