Outlander 4WD L4-2.4L (4B12) (2008)
/Page-838004.png)
4.
Click on "Download". After the download completes, click on "Cancel" to exit the "Maintenance" window.
GO TO THE REPROGRAMMING PROCEDURE SHOWN.
5.
Scan Tool Viewer (STV) ONLY (MEDIC-II USERS go to the Programming Procedure.
4).
Verify that your MUT-III has the most current version of the reprogramming database:
a. Select "Special Function", then select "ECU Reprogramming".
b. Select "Database File Display." The database version is displayed in the top right corner of the screen. Make sure the database version is
N08032 or greater.
c. If the database version is N08032 or greater, reprogram the ECM as described in the Programming Procedure.
d. If the database version is less than N08032, you must transfer the new reprogramming data from the Reflash Update CD 03/08 to the
MUT-III hard drive as follows:
1.
Install Reflash Update CD 03/08 into the PC's DVD-ROM drive.
2.
Follow the instructions on the screen. The system will automatically transfer the reprogramming data onto the PC's hard drive.
3.
Continue to the Reprogramming Procedure.
Reprogramming Procedure
REPROGRAMMING PROCEDURE
BATTERY VOLTAGE (AS MEASURED AT THE BATTERY POSTS WITHOUT ELECTRICAL LOAD) MUST BE KEPT AT 12.4V OR
HIGHER IN ORDER TO REPROGRAM THE ECM. MEASURE THE BATTERY VOLTAGE AND CHARGE AS NECESSARY. DURING
REPROGRAMMING, A BATTERY CHARGER SHOULD BE CONNECTED TO THE VEHICLE'S BATTERY DURING THE
REPROGRAMMING PROCEDURE. DO NOT ALLOW THE BATTERY CHARGER TO TIME OUT.
NOTE:
VCI Stand-alone reprogramming is not available for this procedure. The laptop and the VCI must remain connected for the entire procedure.
Connect the equipment as follows:
^
Turn the laptop computer on. If the battery charge indicator in the lower right hand corner of the screen does not show a full charge, it is
recommended that either the laptop battery be charged prior to beginning, or that reprogramming be completed with the A/C power adaptor
connected to the laptop.
^
Connect the USB cable to the VCI.
