Outlander 4WD L4-2.4L (4B12) (2008)
Removal Steps 1-6 (Part 2)
Required Special Tools:
-
MB991958: Scan Tool (M.U.T.-III Sub Assembly)
-
MB991824:Vehicle Communication Interface(V.C.I.)
-
MB991827:M.U.T.-III USB Cable
-
MB991910:M.U.T.-III Main Harness A
REMOVAL SERVICE POINTS
[[A]] NEGATIVE (-) BATTERY CABLE DISCONNECTION
DANGER: Wait at least 60 seconds after disconnecting the battery cable before doing any further work.
WARNING: Battery posts, terminals and related accessories contain lead and lead compounds. WASH HANDS AFTER HANDLING.
Disconnect the negative (-) battery cable from the battery and tape the terminal to prevent accidental connection and seat belt pre-tensioner operation.
[[B]] LAP PRE-TENSIONER CONNECTOR DISCONNECTION
Use a flat-tipped screwdriver to unlock the locking button of the floor wiring harness side connector. After releasing the lock, disconnect the connector.
[[C]] SEAT BELT PRE-TENSIONER CONNECTOR DISCONNECTION