Outlander 4WD L4-2.4L (4B12) (2008)
NO : Replace the bulb of the ignition key cylinder illumination light.
STEP 6. Check the wiring harness between key reminder switch connector C-211 (terminal No. 7) and body ground.
-
Check the ground line for open circuit.
Q: Is the check result normal?
YES : Go to Step 7.
NO : Repair the wiring harness between key reminder switch connector C-211 and body ground.
STEP 7. Retest the system.
Q: Does the ignition key cylinder illumination light illuminate/extinguish in good condition?
YES : The trouble can be an intermittent malfunction (Refer to general (body and chassis), - How to use Troubleshooting/inspection Service
Points - How to Cope with Intermittent Malfunction).
NO : Replace the ETACS-ECU.