Outlander 4WD L4-2.4L (4B12) (2008)
/Page-1095009.png)
After installing the regulator assembly, insert a piece of wire through the hole in the rear bracket while pressing the brush to keep the brush against
movement.
NOTE: Holding the brush with the wire facilities installation of the rotor
]]B[[ ROTOR INSTALLATION
Remove the brush holding wire after the rotor has been installed.
]]C[[ PULLEY INSTALLATION [2.4L ENGINE]
1. Clean the inner race of the front bearing and that of the pulley.
2. Screws the inner race of the pulley until it touches the inner race of the front bearing.
