Outlander 4WD L4-2.4L (4B12) (2008)
/Page-1205004.png)
1. Install the ball joint remover (Special tool MB991897 or MB992011) as shown in the figure.
2. Turn the bolt and knob to make the special tool jaws parallel, then hand-tighten the bolt. After tightening, check that the jaws are still parallel.
NOTE: To adjust the special tool jaws to be parallel, set the orientation of the knob as shown in the figure.
3. Unscrew the bolt to disconnect the ball joint.
[[B]] FRONT AXLE CROSSMEMBER
ASSEMBLY REMOVAL
1. Jack up and support the crossmember, and remove it.
2. Check the hoses and harnesses for roughness, and then remove the front axle No.1 crossmember assembly with the rear roll stopper and the
steering gear and linkage installed.
INSTALLATION SERVICE POINTS
]]A[[ JOINT COVER GROMMET INSTALLATION
