Outlander 4WD L4-2.4L (4B12) (2008)
Slide the outer housing of the driver's air bag module connector in the arrow direction shown, and disconnect the connector.
[[C]] DRIVER'S AIR BAG MODULE REMOVAL
CAUTION:
^
Never use an electric tester to diagnose the driver's air bag module circuit. Never attempt to disassemble the air bag module.
^
Be sure to store the removed driver's air bag module in a clean and dry place with a pad surface facing upward.
[[D]] STEERING WHEEL ASSEMBLY REMOVAL
1. Position the steering wheel in a straight ahead direction.
CAUTION: Use the special tool to remove the steering wheel since the steering column collision absorbing mechanism may be damaged.
2. Use special tool MB990803 to remove the steering wheel
INSTALLATION SERVICE POINTS
]]A[[ STEERING WHEEL ASSEMBLY INSTALLATION
After centering the clock spring, install the steering wheel assembly.
]]B[[ DRIVER'S AIR BAG MODULE CONNECTOR CONNECTION/STEERING SWITCH CONNECTOR CONNECTION/HORN
CONNECTOR CONNECTION
Connect the connector securely and route the harnesses not to lie off the cover hole.