Outlander 4WD L4-2.4L (4B12) (2008)
/Page-903002.png)
Pull out the selector lever knob to the direction of arrow shown in the figure.
INSTALLATION SERVICE POINTS
]]A[[ TRANSAXLE CONTROL CABLE (TRANSAXLE SIDE) INSTALLATION
1. Move the selector lever and manual control lever to the N position.
2. Use the adjusting nut to tighten the transaxle control cable to the specified torque.
Tightening torque: 9.5 ± 3.5 Nm (84 ± 31 in-lb)
]]B[[ KEY INTERLOCK CABLE INSTALLATION
CAUTION: Leave the ignition switch in the LOCK (OFF) position until the key interlock cable installation is completed.
1. Move the selector lever to the P position and turn the ignition switch to the LOCK (OFF) position.
