Pickup 2WD L4-155 2555cc 2.6L SOHC VIN E 2-bbl (1988)
2.
Open-Circuit Voltage Test: Apply a light load to the battery for 15 sec. and then allow the voltage to stabilize for 2 minutes. A good way to do this
is to turn on the headlights for 15 sec. and then let the battery rest for 2 minutes. The test is performed before and after charging. Record the
open-circuit voltage before charging, even though it may be very low. After charging, the open-circuit voltage must be 12.40 volts or more.
3.
Load Test: After charging, connect a load tester to the battery and load the battery at 200A for 15 sec., and the voltage is read during the test. The
voltage must remain over 9.6V throughout the test in order for the battery to be accepted.
4.
Record all test values on the "Battery Test Procedure" checksheet as they are taken and submit the completed checksheet to your Service Manager.
NOTES ABOUT SAFETY
^
Batteries contain sulfuric acid which is corrosive. Be sure to avoid getting battery electrolyte on skin and clothing, and always wear protective
goggles when working near batteries.
^
Hydrogen gas is generated when a battery is charged. Hydrogen is easily ignited and explodes. Keep sparks and open flames away from batteries.
When connecting a charger, connect the battery leads first before turning on the charger to avoid a spark that might cause an explosion.
^
If a battery gets hot to the touch while charging, discontinue charging. Test the battery for a dead cell. If OK, do not resume charging until the
battery has cooled.
