Pickup 2WD L4-2.3L DSL Turbo (1984)
B.
Check and adjust engine idle speed.
1.
Run engine 5 sec. at 2000-3000 rpm.
2.
Allow engine to idle for 2 minutes.
3.
Using a tachometer, read idle speed. If not 750 rpm +/- 50, adjust to specification using the idle speed adjusting screw. NOTE:
Please note the new location of idle speed adjusting screw on the 1984 turbo diesel engine.
C.
Affix high-altitude label MD075095 to the vehicle
Install the "Vehicle Emission Control Information Update" label MD075095 to the radiator bulkhead in the location shown below.
WARRANTY CLAIM SUBMISSION REQUIREMENTS
1.
Follow normal warranty claim procedures.
2.
Print the High Altitude Installation" across the face of the claim.
3.
Use Labor Operation Code 25-05-30-01.
4.
Use installation time (for all models) 0.3 Hours.
5.
Use Failure Code 99.
