Pickup 2WD L4-2350cc 2.4L SOHC 8 Valve (1996)
Electrical Connections: This is a factory-installed system and is "hard-wired" into the vehicle. Refer to the appropriate service manual for specific
electrical connections.
Transmitter Programming:
1.
With the ignition key off, connect the MUT-II scan tool into the data link connector.
2.
Close all doors and the trunk (or hatch).
3.
Turn the ignition key to "ACC" then to "OFF." The power door locks should cycle, indicating that you are in "Program" mode.
4.
Press either button on the first transmitter slowly three times within ten seconds. The power door locks should cycle after the first transmitter is
programmed.
5.
Press either button on the second transmitter slowly three times within ten seconds. The door locks should cycle after the second transmitter is
programmed.
6.
Disconnect the MUT-II and remove the ignition key.
7. Verify that both transmitters operate properly.
If the transmitters do not operate properly, use the following alternative method:
1.
Gain access to the RKE receiver module. Refer to the appropriate service manual for trim panel removal instructions.
2.
The switch on the receiver module has 3 positions: "SET I", "FIX", and "SET II." (In the normal operating position, the switch should be in the
middle ("FIX") position.) To program the transmitters, first move the switch to one of the "SET" positions.
3.
Press either the LOCK or UNLOCK button on the first transmitter.
4.
Move the switch on the receiver module to the other "SET" position.
5.
Press either the LOCK or UNLOCK button on the second transmitter.
6.
Move the switch on the receiver module to the "FIX" position.
7.
Remove the ignition key and close all vehicle doors and trunk (or hatch).
8.
Verify that both transmitters operate properly.
TRW RKE
RKE TRANSMITTER TROUBLESHOOTING (OMRON ONLY)
If an RKE transmitter will not lock or unlock vehicle doors, transmitter replacement may not be necessary. The battery may be dead or missing. Perform
the following steps before replacing the transmitter:
1. Press each button on the transmitter. If the red indicator lamp comes on when each button is pressed, the transmitter is functioning properly. Do
not replace the transmitter if the indicator light comes on with each button press.
2. If the red indicator lamp does not come on when each button is pressed, replace the battery or batteries.
3. Check the transmitter function again. The indicator light should come on with each button press. If it does not, replace the transmitter.
4. If you replace the transmitter, program the new transmitter.
