Pickup 2WD L4-2350cc 2.4L SOHC 8 Valve (1996)
1. Locate the white RKE programming connector located near the receiver module.
2. Using a jumper wire, connect the two programming connector pins to each other. The doors should lock and unlock to indicate that you are in
programming mode.
3. Press the "LOCK" button on the first transmitter. The door locks should lock and unlock again.
4. Press the "LOCK" button on the second transmitter. The door locks should lock and unlock again.
NOTE: If programming transmitters on a 1992 or 1993 Diamante, you can set up the system so that the doors automatically unlock when the
transmission is shifted into "PARK" as follows:
a. On the first transmitter, press buttons in the following sequence: LOCK-UNLOCK-LOCK- UNLOCK-LOCK-UNLOCK. The door locks
should lock and unlock three times.
b. Repeat the above sequence in step a. with the second transmitter.
5. Remove the jumper wire from the programming connector.
6. Verify that both transmitters operate properly.
Codealarm RKE Only
(Port/Dealer installed - Not included in service manual)
NOTE:
For technical assistance on installing and servicing CodeAlarm Systems, call 800-421-3209 Monday-Friday between 8:00 a.m. and 7:00 pm. or
Saturday between 10:00 a.m. and 2:00 p.m. Eastern Standard Time.
System Operation:
Push the "1" or "LOCK" button to lock all doors. Push the "2" or "UNLOCK" button to unlock all doors and illuminate the dome light for 60 seconds or
until the ignition key is turned to the "ON" position. After the ignition key is turned to the "OFF" position, the dome lamp will remain illuminated for 60
seconds.
Receiver Module Location:
For all models except 1997-98 Diamante, behind knee bolster on driver's side. For 1997-98 Diamante, at base of passenger side "A" pillar.
Ignition Switch Connection:
6-pin ignition switch connector on left side of steering column Ground Connection: Hex bolt on left side kick panel
Courtesy Light Connection:
For all models except 3000GT, at ETACS unit connected to fuse block. On 3OOOGT, under dash on driver's side.
Door Lock Connection:
For all models except 1997-98 Diamante, near the ETACS unit with fuse block. On 1997-98 Diamante models, at engine ECU.
Transmitter Programming:
